Advanced Settings; Mic Serial Number - Bosch MIC440 Installation And Operation Manual

MIC440 Explosion Protected CCTV Camera System| Installation and Operation Manual

Advanced Settings

The Advanced Settings tab offers engineering and special auxiliary control modes
for Pelco and Panasonic protocols (see Help file for details).
The MIC stores various statistics about itself, including temperature and humidity,
and various timers for different parameters, which may be of interest to the end
user, but are mainly implemented as an engineering tool.
Temperature and Humidity
This will only work if the MIC400 has the appropriate control card with the
temperature and humidity sensor attached. Current,
Bosch Security Systems
Max and Min are displayed for
Issue 6
both in degrees and a percentage respectively. If the MIC reaches 70% humidity
inside the head a small "H" is displayed in the top left corner indicating a Humidity
problem. If this appears, make contact with Bosch Security Systems.
Timers
The timers monitor most of the common functionalities of a MIC: Panning, Tilting,
On Tour, Since Built, Stationary, Wiping and IR Lamp shown in Weeks, Days,
Hours, Minutes and Seconds.
Clear All Statistics
This function will set Max and Min for temperature and humidity to the current
reading, and will clear all of the timers to "0". This feature should only be used
when a MIC is first built or repaired, and therefore is locked out with the Advanced
Controls Password.

MIC Serial Number

This feature is used to set or read the actual MIC Serial Number. This may be
required to reprogram the MIC through the telemetry. The Set function is locked
out with the Advanced Password as this should only be performed at the
manufacturing stage, however read is available to use as required.
EN | 37