Table of Contents
Advertisement
54
en | Encoder Settings
9.1.3
Profile name
If required, enter a new name for the profile.
9.1.4
Target bit rate
To optimize use of the bandwidth in the network, limit the data
rate for the camera. The target data rate should be set
according to the desired picture quality for typical scenes with
no excessive motion.
For complex images or frequent changes of image content due
to frequent movements, this limit can temporarily be exceeded
up to the value entered in the Maximum bit rate field.
9.1.5
Maximum bit rate
This maximum data rate is not exceeded under any
circumstances. Depending on the video quality settings for the
I-frames and P-frames, this can result in individual images being
skipped.
The value entered here must be at least 10% higher than the
value entered in the Target bit rate field. If the value entered
here is too low, it is automatically adjusted.
9.1.6
Encoding interval
The Encoding interval slider determines the interval at which
images are encoded and transmitted. This can be particularly
advantageous with low bandwidths. The image rate in ips
(images per second) is displayed next to the slider.
9.1.7
Standard definition video resolution
Select the desired resolution for the standard definition video
image.
Note:
These resolutions are not used by a HD (MP) stream.
9.1.8
Expert Settings
If necessary, use the expert settings to adapt the I-frame quality
and the P-frame quality to specific requirements. The setting is
based on the H.264 quantization parameter (QP).
AM18-Q0649 | v5.8 | 2013.06
Software manual
Camera Browser Interface
Bosch Security Systems
Hide quick links:
Advertisement
Table of Contents
