Elba P60 Installation And Instruction Manual page 17

FITTING THE BATTERY IGNITION
SUPPLY
Remove pan supports and burners
from the cooktop.
Turn over the cooktop: be carefull to
lay on a soft surface so that it cannot
be damaged.
Connect the battery cable plug to the
socket as indicated in figure 3.4.
Fit the cooktop into the cabinet unit as
described in the Installation chapter.
Fix the battery holder to the cabinet
unit (figures 3.5 - 3.6) with 2 suitable
screws (not supplied). We suggest to
position the support as per figure 3.5,
on the left wall of the cabinet. Then fix
the cable to the cabinet wall with suit-
able clamps (not supplied).
Important: do not secure the bat-
tery support to the hob casing.
Insert a type AA battery (1.5 Volt) into
the battery holder (fig. 3.7).
NOTES FOR BATTERY INSTALLATION OR
REPLACEMENT:
Only use a type AA 1.5 Volt battery.
Check for correct polarity (fig. 3.7).
Important notes:
Remove the battery if the cooking hob
is not going to be used for a long
time.
If the battery leaks, replace it immedi-
ately. Avoid touching the leaked liquid
and make sure it does not come into
contact with clothes or other items.
Clean the battery compartment care-
fully before installing the new one.
Note: The battery is a potential
source of danger for children. Keep
them away.
Dispose of flat batteries properly.
Fig. 3.7
17