NTT docomo Optimus LTE L-01D Instruction Manual page 49

Ntt docomo optimus lte l-01d smartphone
Table of Contents

Advertisement

Note
• A data connection (LTE/3G/GPRS) is required
to set online services. For details on enabling
data connection, refer to "Wireless & Networks"
(P101).
Configuring Wi-Fi Settings
The terminal connects to the Internet via access points
for Wi-Fi networks or public wireless LAN services.
To connect, you must configure the access point
connection settings on the terminal.
„ Reception interference caused by Bluetooth devices
• As the terminal's wireless LAN devices and
Bluetooth device use the same frequency
(2.4 GHz), reception interference may occur or the
communications speed may lower. Also, you may
hear noise or have a connection problem. In these
cases, do the following:
- Keep the wireless LAN device over 10 m away
from the Bluetooth device.
- Within 10 m, turn off either the wireless LAN
device or the Bluetooth device.
Note
• Packet communication can be connected, even
when Wi-Fi function is ON. However, while Wi-
Fi is available, Wi-Fi is prioritized. When the
Wi-Fi network is disconnected, the terminal
automatically connects to the LTE/3G/GPRS
network. Packet communication charges apply
if you use it with LTE/3G/GPRS connected.
• You can reduce battery consumption by turning
OFF Wi-Fi when you are not using it.
Wi-Fi network status
When the terminal is connected to a Wi-Fi network,
appears in the status bar. An open network with
no security protection is detected when Wi-Fi network
notification is set to ON,
bar.
Confirmation and Settings before Using
always appears in the status
47

Advertisement

Table of Contents
loading

Table of Contents