Channel Format; Routing Protection - Studer OnAir 3000 Operating Instructions Manual

5.8.2

Channel Format

5.8.3

Routing Protection

Date printed: 31.10.08
The channel format is not fixed as it usually is in a production console, but
it automatically follows the format of the routed input source instead. This
means that when routing a mono input source to a console channel forces the
channel to operate in mono mode, and routing a stereo input source forces
the channel to operate in stereo mode.
The channel format affects the controls in the channel pages. This is visible in
the CHAN - Input page, where the LR/RL/LL/RR/Mono buttons are shown
for stereo channels only, and in the CHAN - FDR/Bus page, where either a
PAN field is shown for mono channels or a BAL field for stereo channels.
Formats are automatically adjusted. This means that if a channel is currently
in stereo mode and its signal is routed to a mono AUX output, the system
automatically inserts a mono summing matrix into the signal path between
the channel and this AUX output.
If a channel is currently on-air (i.e., channel ON, channel fader open, channel
routed to a master being on-air, master fader open), the input source cannot
be changed before the channel becomes inactive. However, hot-swapping of
channels is always allowed.
Connections can be protected in the configuration (e.g. the master chan-
nels).
SW V3.0
OnAir 3000 Digital Mixing Console
Operation 5-83