Studer OnAir 3000 Operating Instructions Manual page 228

OnAir 2500/OnAir 3000 Digital Mixing Consoles
GPO Function
FaderstartWithPFL
FaderstartWithoutPFL
RedLight_ONAIR
RedLight_PGMA
* RedLight_PGMB
RedLight_REC
* RedLight_5.1A
* RedLight_5.1B
RedLight_CR
* RedLight_ST1
RedLight_ST2
* RedLight_ST3
RedLight_Input
MicMuteActive
ON
** TransparentOut
** LinkOutput
UserKey
TB
Locate
OnMaster
Next_Out
MicGroupReady
MicGroupActive
MicGroupOnAir
Setup
LastSnapshot
OutputRoutingOut
** ForwardInput
* OnAir 3000 only
** See paragraph "Notes" at the end of this chapter
6-60 Confi guration
On power up, Level is initialized according to the input signal.
Notes:
Time, Polarity, and Triggered Edge must not be changed while the GP
output is active.
For correct take-over after a modification, it is important to select Activate
to On, because it is automatically set to Off when a modification is made.
Arguments
Logical Input
Logical Input
-
-
-
-
-
-
-
-
-
-
Logical Input
Logical Input
Logical Input / Strip Channel / AUX / N–X
Device ID
GP Output pin
Device ID of a user key parameter
Sources: CR/*ST1/ST2/*ST3 / External
Destinations: All TB destinations
Logical Input
Logical Input
StartNextA/B_State
MicGroup
MicGroup
MicGroup
Setup1 / Setup 2
PrimaryDesk/*SecondaryDesk/Not Spec. /
All/CR/*ST1/ST2/*ST3 / String
Partial Output Routing
GP Input Pin
SW V3.0
Description
Fader start with ON key and fader, or PFL
Fader start with ON key and fader
Active if the ON AIR LED is on
Active if PGM A is on air
Active if PGM B is on air
Active if REC is on air
Active if 5.1 A is On Air
Active if 5.1 B is On Air
Active if Control Room red light indication is on
Active if Studio 1 red light indication is on
Active if Studio 2 red light indication is on
Active if Studio 3 red light indication is on
Active if specified strip channel is ON
Active if mic is muted
Active if ON key is ON
Active if the value of the specified parameter is different from
zero (this function is normally used for factory testing only).
Only 64-bit device ID numbers in hex format are accepted as
argument 1 – i.e., 0x followed by 16 digits
(e.g. 0x1122334455667788)
Links the GP output to another GPO function
Active if the value of the specified user key parameter is true
Active if the specified Talkback from Source to Destination is
active (Source = Destination is not allowed)
Active if LOC/READY key of the logical input is on
Active if channel on master is active
Flashing if status = Ready, continuous if status = Next
Active if ext. mic group key is Ready
Active if ext. mic group key is Active or On Air
Active if ext. mic group key is On Air
Active if the specified setup is active
Active if the last loaded Global Snapshot is the one with the
name specified by "string"
Active if the cross points of the specified partial output routing
are set as specified by "string"
Active if the specified input pin is active
Date printed: 21.01.09