Section.1:.Landing.gear.installation - Hangar 9 Pulse XT 40 Plug-N-Play Assembly Manual

Section 1: Landing Gear Installation
Required Parts
•.Fuselage.
•.6-32.x.1/2".socket.head.screw.(3)
•.#6.washer.(3)
•.Wheel.pant.(right.and.left)
•.4-40.x.3/8".socket.head.bolt.(4)
Required Tools and Adhesives
•.Hex.wrench:.3/32",.7/64". •.Threadlock

.Step 1
Attach.the.landing.gear.to.the.bottom.of.the.fuselage.using.
three.6-32.x.1/2".socket.head.bolts.and.three.#6.washers..
Put.a.little.threadlock.on.the.bolts.to.prevent.them.from.
vibrating.loose.during.flight.
8
•.Landing.gear
 
. .Step 2
Secure.the.wheel.pant.to.the.landing.gear.using.two..
4-40.x.3/8".socket.head.screws..Make.sure.to.use.
threadlock.to.prevent.the.screws.from.loosening..
during.flight.
 
. .Step 3
Check.that.the.wheel.can.spin.freely.without.rubbing.on.
the.wheel.pant..If.it.does,.loosen.the.4mm.nut.and.4mm.
locknut.and.reposition.the.wheel.so.it.can.spin.freely.

.Step 4
Repeat.Steps.2.and.3.to.install.the.remaining..
wheel.pant.