Section.5:.Wing.installation - Hangar 9 Pulse XT 40 Plug-N-Play Assembly Manual


.Step 5
Use.a.crescent.wrench.to.tighten.the.propeller.nut.
Section 5: Wing Installation
Required Parts
•.Fuselage.
•.Wing.bolt.plate.
•.1/4-20.x.1 1 / ".nylon.bolt.(2)
. 2
•.1 5 / ".(33mm).wing.dowel
.
16
Required Tools and Adhesives
•.Thin.CA.

.Step 1
Slide.the.wing.tube.and.the.1
into.one.of.the.wing.panels.
•.Wing
•.Wing.tube
•.Phillips.screwdriver
5 / ".(33mm).wing.dowel.
. 16
Section 4: Spinner Installation

.Step 6
Secure.the.spinner.cone.to.the.spinner.backplate.using.
two.3mm.x.12mm.sheet.metal.screws.

.Step 2
Slide.the.remaining.wing.panel.onto.the.wing.tube.
aligning.the.dowel.into.the.panel.

.Step 3
Slide.the.1/4-20.x.1 1 / ".wing.bolts.through.the.wing.
. 2
bolt.plate..Position.the.wing.dowels.into.the.holes.in.the.
fuselage..Slide.the.bolts.through.the.wing.and.tighten.
them.to.secure.the.wing.to.the.fuselage.
13