Installing The Truma Aquago™ Instant Water Heater - Truma AquaGo basic Operating Instructions Manual

Installing the Truma AquaGo™
instant water heater
Before installation, read the chapterrefer to
"Preparing for installation" on page 17
and the following.
Sharp edges can cause cuts and injury!
• Always wear protective gloves to avoid
injuries from sharp edges during installa-
tion work and while handling the Truma
AquaGo™ instant water heater.
1. Slide the appliance carefully into the installa-
tion space until the installation frame makes
contact.
2. Make sure that the gas line connects per-
pendicularly to the Truma AquaGo™ instant
water heater's gas connection and without
tension.
3. If the connection is OK, push the gas line
back.
It will be connected in a later step.
4. The Truma AquaGo™ instant water heater
must be installed with a watertight seal with
the outer skin of the vehicle.
Damage to the Truma AquaGo™ instant
water heater and/or the RV!
• Do not use adhesive sealing material (e.g.
silicone) for the watertight seal. Otherwise
damage may occur when the appliance is
moved when performing service.
To achive the watertight seal:
• Pull the Truma AquaGo™ instant water
heater out ≈ 2" (5 cm).
• Apply an adequate amount of watertight
sealing material to the entire flange area of
the installation frame and at the corners,
see grey marking in Fig. 15.
• Slide the Truma AquaGo™ instant water
heater carefully into the installation space
until the installation frame makes contact.
Fig. 15
5. Screw the Truma AquaGo™ instant water
heater into the vehicle's prepared frame with
14 screws. The screws must be suitable for
the chosen frame material and have a diam-
eter of 0.138" (#6) to 0.164" (#8).
6. Make sure that the unit casing corners are
90 degrees square so that the cover plate/
access door fits properly.
14 x
Fig. 16
7. Immediately remove all excess sealing
material.
Risk of death of poisoning and significant
damage to the RV due to exhaust gas and
leaking water!
• Make sure that there is a tight seal and that
no exhaust gas or water can enter the RV.
8. Check and make sure that there is a tight
seal.
9. Fasten the cover plate to the Truma
AquaGo™ instant water heater (see Fig. 17):
• Position the cover plate.
• Screw the cover plate only loosely. Start
with screw 1.
• Align the cover plate.
• Uniformly tighten all 8 screws.
8 x
Cover plate
Fig. 17
90 degrees
1
21