Functional Check - Truma AquaGo basic Operating Instructions Manual

Damage of the flare fitting!
The flare fitting is a dry seal.
• Never use pipe dope on the flare fitting.
3. Screw the gas line's union nut (wrench size
3/4") onto the Truma AquaGo™ instant water
heater's gas connection so it is finger-tight.
Gas valve may be damaged during
tightening!
• Use a second wrench to counterhold at the
square end (wrench size 11/16").
4. Use a torque wrench to tighten the union nut
(nominal torque 15 lb-ft / 20 Nm).
Risk of poisoning and/or explosion!
Improper tightening of the cable tie could re-
sult in gas/exhaust entering the RV.
• Close the cable tie so that the grommet
tightens the gas pipe passage.
• A cable tie is provided with the Truma
AquaGo™ instant water heater. You will find
it fixed to the gas valve.
5. Put a cable tie around the grommet and
tighten it (see Fig. 20).
Checking for gas leaks
Risk of death and personal injury through
fire and/or explosion!
• DO NOT use matches, candles or other
sources of ignition when checking for gas
leaks.
• After the gas supply is connected, check for
gas leaks at all gas connections. Use a gas
leak detection liquid.
1. Turn OFF the electrical power supply.
2. Turn on the gas.
3. Check the Truma AquaGo™ instant water
heater and all gas connections for gas leaks
with leak detection liquid.
Bubbles indicate a gas leak that must be
repaired.
4. Repair gas leaks as needed.
5. Repeat check for gas leaks at all gas
connections.

Functional check

1. Bring the Truma AquaGo™ instant water
heater into operation (refer to "Placing
Truma AquaGo™ instant water heater in
operation" on page refer to "Placing Truma
AquaGo™ instant water heater in operation"
on page 8).
2. Check the Truma AquaGo™ instant water
heater for proper functionality.
3. Provide operating and installation instruc-
tions to the vehicle owner.
The Truma AquaGo™ instant water heater is
now ready for normal operation and use.
23