Connecting The On-Off Led Harness To The Fireplace - DaVinci fireplace Owner's Manual

50

Connecting the On-Off LED Harness to the Fireplace

Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace.

The On-Off LED harness is available in various lengths (see page 13 for details).

Route the On-Off LED harness through the cover plates and attach to the molex connector and quick-
connects on the fireplace as shown below.
HINT: Keep the cover plates disconnected until all wiring to the fireplace is attached. You may also
wish to leave the romex clamps loose until the cover plates are ready to be attached.
LED Molex
Connector
On-Off
Wires

The opposite end of the On-Off LED harness attaches to the on-off switch and LED controller (see
"Installing the On-Off Switch and LED Controller" on the following page for details).
© Travis Industries
Installation
On-Off LED
Harness
(for qualified installers only)
Inner Cover Plate
Romex Clamp
Grommet
(remove to install wire)
4150126
Outer Cover Plate
1/4" Nutdriver
100-01418