Before You Begin; Starting The Heater For The First Time; Location Of Controls; Fireplace On/Off Operation - DaVinci fireplace Owner's Manual

80

Before You Begin


Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.

Starting the Heater for the First Time


Condensation may appear on the glass each time you start the heater - this is normal.

Blue Flames will occur on the heater when it first comes on. After fifteen minutes the flames will turn
a more realistic yellow and orange color.

NOTE: Whenever power is connected to the fireplace (e.g.: power outage or breaker re-set),
the exhaust blower will turn on and run for approximately 6 minutes).

Location of Controls

LED - Dimmer Control

Fireplace On/Off Operation

The fireplace takes approximately 30 seconds to turn on after the switch is
turned to the "ON" position.
Use the on/off switch to turn the fireplace on and off.

LED Operation

Use the LED dimmer control to turn the LEDs on. As you move the slider upwards, the LEDs will become
brighter.
The LED color control may be used to change the color of the LEDs. As you move the slider upwards,
the LEDs will change color.
NOTE: In certain color positions, the LED lights may emit a slight flickering as it moves between colors.
This anomaly is normal – simply move the color control to suit your preference.
© Travis Industries
Operation
LED - Color Control
4150126
Fireplace On/Off Switch
100-01418