Tension Rod Installation; Place The Fireplace On The Alignment Track - DaVinci fireplace Owner's Manual

18

Tension Rod Installation

Insert the tension rods into the fireplace from the side. Each tension rod is approximately the same width
as the fireplace –make sure to use the correct rod when using modules of dissimilar lengths. After
inserting the rods, attach the coupling nuts and bolts so they remain in place (remove access panel to
gain access).
NOTE: Do not tighten the tension rods until the titan connectors are in place and the glass opening is
aligned – see "Order of Intallation".

Place the Fireplace on the Alignment Track

Place the fireplace on the alignment track. Take care to prevent damage to the fireplace. Make sure the
fireplace sections are separated to allow for shipping end cap removal.
NOTE: We strongly recommend the use of one (or two) Escalara lifts (or a forklift) when installing the
fireplace. This greatly reduces the chance of damage to the fireplace or injury to installers.
NOTE: You may wish to leave one or both side of the framing open to allow for fireplace placement and
assembly – especially on one-sided or bay installations. The framing may be temporarily removed to
allow for fireplace placement, then replaced once the fireplace is in place and assembled. Do not attempt
to place the fireplace modules in place unless you have sufficient room (minimum 12" 300mm) to access
the sides of the fireplace modules.
© Travis Industries
Installation
(for qualified installers only)
4150126 100-01418