Connecting The Intake Damper Harness To The Fireplace - DaVinci Maestro Collection Square Owner's Manual

24

Connecting the Intake Damper Harness to the Fireplace

WARNING: DO NOT CONNECT THE INTAKE DAMPER WIRES TOGETHER
(this will short the system).

The 25' intake damper harness is shipped in the hardware box (see page 8 for details). If additional
length is needed, use part 250-02295 (typically ordered when fireplace is configured) or 18 gauge
wire.

Route the intake damper harness through the cover plate and attach to the molex connector on the
fireplace as shown below. The other end is attached to the damper(s).
HINT: Keep the low voltage cover plate disconnected until all wiring to the fireplace is attached. You
may also wish to leave the strain reliefs/clamps loose until the cover plate is ready to be attached.
Use pliers to compress the
strain relief when inserting
or removing it from the hole.
© Travis Industries
Installation
9/25/17-1468
(for qualified installers only)
Intake Damper
Harness
(remove to install wire)
Low Voltage
Cover Plate
1/4" Nutdriver
Strain Relief
Maestro