Emergency Transmission; Priority A Channel Selection; Power Off Emergency Function - Icom IC-F5062 Instruction Manual

■ Emergency transmission

When [Emergency] is pushed for the specified time period,
an emergency signal is automatically transmitted. (p. 6)
When [Emergency] is pushed for the specified time period,
the DTMF or 5-Tone* emergency signal is transmitted once
or repeatedly on the emergency channel. However, when no
emergency channel is specified, the signal is transmitted on
the previously selected channel.
If you want to cancel the emergency call, push and hold the
key again before transmitting the call.
D NOTES
Depending on the presetting, the following functions are auto-
matically activated. Ask your dealer for details.
• Auto TX function
After the emergency call transmission, audio from the micro-
phone is automatically transmitted for a specified time period.*
• Auto RX function
After the emergency call transmission, the transceiver stands
by in the audible mode for the specified time period.*
* Depending on the operating model type.

■ Priority A channel selection

When one of the following operations is performed, the trans-
ceiver selects the Priority A channel automatically.
• Turning the power ON
The Priority A channel is selected each time the transceiver
power is turned ON.
• Status call
The Priority A channel is selected when transmitting a sta-
tus call. (BIIS operation only)
• Off hook.
The Priority A channel is selected when the microhone is
took off from its hanger.

■ Power Off Emergency function

If the new function key, [Power OFF Emergency], is assigned
to any key, you can use the Power OFF Emergency function.
To activate the Power OFF Emergency function, turn the
transceiver's power OFF while pushing and holding [Power
OFF Emergency].
After the specified time period has passed, from the time this
function is activated, the emergency call is transmitted (with
no beep emission and no display indication).
If you want to cancel the emergency call, turn the transceiv-
er's power ON.
And also, depending on the pre-setting, the Remote Monitor
function can be used while this function is activated.
2
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
13