Table of Contents
Advertisement
•
Driving wheels (rear wheels)
L L L L
WARNING:
Risk of injury - Make sure all screws are firmly secured by hand
before driving with your electric wheelchair.
DISMANTLING
1. Loosen and remove the wheel fastenings
2. Take the complete rear wheel
ASSEMBLY
1. Make the threads and Motor axle free from dirt and grease the threads.
2. Mount the rear wheel on the motor axle so that the wheel hub fits on the motor axle
groove.
3. Secure the wheels firmly with the nut (wheel fastenings
4
Maintenance
L L L L
CAUTION: Risk of electrical shocks - Disconnect the batteries to prevent any
unwanted current flow before performing any maintenance work.
Lifetime of the electric wheelchair is strongly influenced by its use, storage, regular
maintenance, servicing and cleaning.
The device is flame resistant. An escalate burning of the seat and back cushion was not
detected during the flammability test with a match-flame equivalent ignition source.
4.1
Regular Maintenance
The maintenance activities to ensure a good condition for your Vermeiren wheelchair are
described below:
•
Before every ride
Check the tyres for visible damage and/or soiling. Remove any dirt as it could
impair the motion of the tyres. When a tyre is damaged, please go see an
authorized workshop for repair.
Check the tyre pressure and inflate them if necessary (only for air tyres).
Check the motor brakes, parking brakes and replace if necessary.
See that all the screws are tightened properly.
Check the electric wheelchair (cleanliness, cracks, damage on structural parts ...)
and make it clean. If necessary change the coating.
Switch on the electronics after verifying that the motor is engaged. The operator
unit indicates the level of the batteries. If the battery charge is not sufficient for
the intended route, switch off the operator unit and charge the batteries.
1 = Motor axle
2 = Rear wheel
3 = Wheel fastening
.
from the motor axle
Page 27
.
).
Express
2012-03
Advertisement
Table of Contents
