Adjusting The Stability And The Maneuverability; Maintenance - Vermeiren V300 XL Instruction Manual

Height armpad to seat
220 mm (Standard)
230 mm
240 mm
The depth of the armpad can be adjusted in 3 positions.
Depth of the armpad
Front position
Middle position (Standard)
Back position
Adjust the height and the depth of the armpad as follow:
1. Remove both screws under the armpad.
2. Place the correct number of blocks under and above the tubes, see table 4.
3. Install the armpad with the required holes for depth adjustment.
3.8

Adjusting the stability and the maneuverability

The stability and maneuverability can be adjusted by moving the axle plate of the rear
wheels .
4

Maintenance

For the maintenance manual of the wheelchairs refer to the Vermeiren website:
www.vermeiren.be.
Number of the blocks
under the tube
2
1
0
Table 4: Height of armpad
Back and middle
Front and middle
Table 5: Depth of armpad
Adjust the stability and maneuverability according
following steps:
1. Loosen the bolts of axle plate.
2. Move the axle plate
3. Retighten the bolts.
Page 19
Number of blocks between
tube and armpads
1
2
3
Used holes
Hole 2 and 4
in the desired position.
V300 XL
2013-11