Table of Contents
Advertisement
2.13.3
Adjusting operator unit
L L L L
CAUTION:
Risk of pinching - Do not put your fingers between the operator
control and the other parts when positioning the operator unit.
The operator unit's horizontal position can be changed:
1. Loosen screw
just under the arm rest a little bit.
2. Move the operator unit to the desired position or remove the operator unit.
3. Retighten screw
If you pull screw
to the side, the operator unit can be turned to the side.
NOTE: Depending on the features of your wheelchair, screw
beneath the guide tube ➁ .
2
2.13.4
Connections for charger / program unit
L L L L
WARNING:
Risk of injury - Check that all plugs (battery charger and
programming unit) are removed before setting the wheelchair in motion.
properly.
1
The socket
for connecting the charger supplied is located on the
front of the operator unit. Here, too, is the connnection for the
programming unit, which should only be connected and used by
authorised persons who have been trained to program it (Vermeiren
personnel).
Make sure that the joystick is in the neutral (central) position
when pressing the on/off button, otherwise the electronics will
be blocked. This block can be lifted by switching the control
unit off and then on again.
Page 15
Express
2012-03
could also be located
Advertisement
Table of Contents
