Maintenance - MasterCraft 058-8434-4 Instruction Manual

23

Maintenance

MAINTENANCE
REQUIRED
General inspection -
free movement
In-depth inspection
Replace worn or
broken parts
Lubrication
• Lubrication: If the Air-powered Clipped-head
Framing Nailer and the compressor are not
equipped with an in-line lubrication system, place
up to 6 drops of pneumatic tool oil into the air inlet
before each work day or after every 2 hours of
continuous use, depending on the characteristics
of the workpiece and type of nails used.
DANGER!
Potential hazard that will result in serious injury or loss of life.
• Disconnect the tool from the air compressor before performing maintenance/
service, adjusting, clearing jams, reloading, and when it is not in use.
• Repairs must be performed by a qualified service technician only. Failure to
comply will lead to serious injury or loss of life.
DESCRIPTION
Trigger, spring,
safety mechanism
Worn or broken
parts
See below
AIR-POWERED CLIPPED-HEAD FRAMING NAILER 058-8434-4
MAXIMUM SERVICE INTERVAL
TOOLS OR
MATERIALS
Each Use or
REQUIRED
every 2 Hrs
None X
Pneumatic tool
X
oil
As
Monthly
Needed
X X
X
MC-588434-18