MasterCraft 058-8434-4 Instruction Manual page 17

17
3. Insert a strip of nails into the magazine.
Ensure the points of the nails are facing
down. Be sure to insert the heads of the
nails into the channel. Slide the pusher
against the nails to close the magazine
(1) until it comes into contact with the
nails and locks into place. The tool is
now ready for use
nail type icon on page 15)
4. Plug in compressor, turn it on set the
pressure regulator to 90psi, attach one
end of the air hose to the compressor
and the other end of the air hose (1) to
the tool (2). Use plumber's tape to avoid
air leak
(wood density chart)
5. Test the driving depth using a sample
piece of wood before working on the
workpiece. If the nails are being driven
too deep or not deep enough, adjust the
regulator in order to provide more or
less air pressure, as required.
(fig E) .
(fig F) .
page 12
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not operate the tool if the nails are not loaded, doing so may damage the
tool.
• Do not fire nails into the air, doing so may cause injury to the operators or
others, apart from damaging the tool.
• Load the correct type of nails only and do not load different sized nails into
the magazine, as doing so may cause nails to jam. Failure to comply could
lead to serious injury or loss of life.
AIR-POWERED CLIPPED-HEAD FRAMING NAILER 058-8434-4
fig E
(see
fig F
1
2
MC-588434-08
1
2
MC-588434-09