Installing The New Trigger - MasterCraft 058-8434-4 Instruction Manual

INSTALLING THE NEW
TRIGGER
• Place the new trigger (1) with your
thumb holding the spring (2) in place
(fig I) .
• Align the holes on top of the trigger
and the holes on the casing of the
nailer.
• Insert the trigger pin (1) through the
holes. Put it back to where it was
(fig J) .
removed
• Push the O-ring back on to the trigger
pin. Make sure it is tightly secured and
sits in the recess.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Do not attempt to modify the trigger components in any manner and do not
attempt to use any other trigger components other than those intended for
this tool. Failure to comply will lead to moderate injury or damage to
equipment.
AIR-POWERED CLIPPED-HEAD FRAMING NAILER 058-8434-4
fig I
2
fig J
1
20
1
MC-588434-12
MC-588434-13