Motherboard Installation; Tools Needed; Location Of Mounting Holes - Supermicro SUPERO X10DRW-i User Manual

X10DRW-i/X10DRW-iT Motherboard User's Manual
2-5

Motherboard Installation

All motherboards have standard mounting holes to fit different types of chassis.
Make sure that the locations of all the mounting holes for both motherboard and
chassis match. Although a chassis may have both plastic and metal mounting fas-
teners, metal ones are highly recommended because they ground the motherboard
to the chassis. Make sure that the metal standoffs click in or are screwed in tightly.
Then use a screwdriver to secure the motherboard onto the motherboard tray.

Tools Needed

•
Phillips Screwdriver
•
Pan head screws (10 pieces)
•
Standoffs (10 pieces, if needed)

Location of Mounting Holes

There are ten (10) mounting holes on this motherboard indicated by the arrows.
IPMI
Flash
I-SGPIO2
I-SGPIO1
JPME2
JL1
Caution: 1) To avoid damaging the motherboard and its components, please do
not use a force greater than 8 lb/inch on each mounting screw during motherboard
installation. 2) Some components are very close to the mounting holes. Please take
precautionary measures to prevent damage to these components when installing the
motherboard to the chassis.
UID-SW
SP1
BMC
J35
BIOS
PCH
JBT1
LED2
JSTBY1
LAN1 USB2/3(3.0)USB0/1(3.0)
LAN2
LAN
CTRL
X10DRW-i(T)
Rev. 1.01
CPU2
CLOSE 1st
OPEN 1st
BIOS
LICENSE
CPU1
CLOSE 1st
OPEN 1st
JVR1
2-14
VGA
IPMI_LAN