Power Configuration - Supermicro SUPERO X10DRW-i User Manual

Chapter 4: AMI BIOS
Wait For 'F1' If Error
Select Enabled to force the system to wait until the 'F1' key is pressed if an error
occurs. The options are Disabled and Enabled.
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this
item is set to Immediate, the ROM BIOS of the host adaptors will "capture" Inter-
rupt 19 at bootup immediately and allow the drives that are attached to these host
adaptors to function as bootable disks. If this item is set to Postponed, the ROM
BIOS of the host adaptors will not capture Interrupt 19 immediately and allow the
drives attached to these adaptors to function as bootable devices at bootup. The
options are Immediate and Postponed.
Re-try Boot
When EFI Boot is selected, the system BIOS will automatically reboot the system
from an EFI boot device after its initial boot failure. Select Legacy Boot to allow
the BIOS to automatically reboot the system from a Legacy boot device after its
initial boot failure. The options are Disabled, Legacy Boot, and EFI Boot.

Power Configuration

DeepSx Power Policies
Use this feature to configure the Advanced Configuration and Power Interface
(ACPI) settings for the system. Enable S3 to use Standby Mode (Suspend-to-RAM)
and maintain power supply to the system RAM when the system is in the sleep
mode. Enable S4 to use Hibernation mode (Suspend to Disk) so that all data stored
in of the main memory can be saved in a non-volatile memory area such as in a
hard drive and then power down the system. Enable S5 to power off the whole
system except the power supply unit (PSU) and keep the power button "alive" so
that the user can "wake-up" the system by using an USB keyboard or mouse. The
options are Disabled, Enabled in S5, Enabled in S4-S5, and Enabled in S3-S4-S5.
Watch Dog Function
Select Enabled to allow the Watch Dog timer to reboot the system when it is inac-
tive for more than 5 minutes. The options are Enabled and Disabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed.
Select 4 Seconds Override for the user to power off the system after pressing and
holding the power button for 4 seconds or longer. Select Instant Off to instantly
power off the system as soon as the user presses the power button. The options
are 4 Seconds Override and Instant Off.
4-5