Table of Contents
Advertisement
X10DRW-i/X10DRW-iT Motherboard User's Manual
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Note 1. For an ATX power supply, you must completely shut down the
system, and then short JBT1 to clear CMOS.
Note 2. Clearing CMOS will also clear all passwords.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
will reboot the system when a software ap-
plication hangs. Close pins 1-2 to reset the
system if an application hangs. Close pins
2-3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
B
SP1
BMC
IPMI
J35
Flash
BIOS
PCH
I-SGPIO2
A
I-SGPIO1
JBT1
LED2
JPME2
JSTBY1
JL1
LAN1 USB2/3(3.0)USB0/1(3.0)
LAN2
UID-SW
LAN
CTRL
X10DRW-i(T)
Rev. 1.01
CPU2
CLOSE 1st
BIOS
LICENSE
CPU1
CLOSE 1st
OPEN 1st
JVR1
2-34
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA
IPMI_LAN
OPEN 1st
Definition
Reset (default)
NMI
Disabled
A. Clear CMOS
B. Watch Dog Enable
Hide quick links:
Advertisement
Table of Contents
