Chapter 3: Mount The Device; Positioning On A Table; Mounting In A Rack; Front Mounting Bracket Placement - Avaya G350 Quick Start For Hardware Installation

Chapter 3: Mount the Device

You can position the Avaya G350 Media Gateway on a suitable table, or mount it in a rack or on
the wall.

Positioning on a Table

To install the Avaya G350 Media Gateway as a tabletop unit:
1. Remove the four rubber standoffs from their package.
2. Turn the G350 upside down.
3. Position each standoff into one of the mounting sites, near each corner of the chassis.
4. Press the plastic rivet into the standoff with a stylus until the rivet is firmly seated on the
chassis.

Mounting in a Rack

You can fasten the G350 to a standard 19-inch rack either at the front of the G350 or at its
middle. Before you mount the G350, attach the mounting brackets to the device.

Front Mounting Bracket Placement

Attach a regular mounting bracket to one side of the G350, near the front, as shown in
Figure 1: Front mounting bracket placement
guides to the other side of the G350 (refer to
guides on page 17).

Middle Mounting Bracket Placement

Attach regular mounting brackets to the sides of the G350, as shown in
mounting bracket placement
side of the G350, as shown in
page 17.
on page 16. Attach a mounting bracket with cable
Figure 3: Attaching a mounting bracket with cable
on page 16. Attach a mounting bracket with cable guides on one
Figure 3: Attaching a mounting bracket with cable guides
Figure 2: Middle
on
Issue 4 February 2006 15