Scan All - Simrad Shipmate RS8400 Introduction Manual

Scan All mode monitors all channels for transmissions. *
Squelch must be set above level 1 before this mode can be selected. The Scan
function will go in Stand-by mode if the handset is out of its cradle.
* In Europe Channel 16 is always monitored.

SCAN ALL

- -
*
SCAN ALL
10
INT SB
10
18
Activate/terminate Scan All.
While scanning is in progress, channel numbers
will not be displayed.
When a transmission is detected, the set will lock
on for four seconds and display the number of the
channel.
When a handset is lifted, the scanning stops and
goes in stand-by mode. The display will show the
last received channel.