Scan Mode; Inhibit / Enable Channel From Scan - Simrad RD68 User Manual

2.11 Scan mode

Press Adv to manually
advance to the next channel in
NOTE
1. While in scan mode
INT
S S c c a a n n
I I n n h h
Scan
E03912
The scan function cycles the RD68 sequentially through each
enabled channel, pausing when a signal is detected.
the scan sequence
While in scan mode, normal VHF functions are not available. To
exit scan mode, press C or 16.

2.11.1 Inhibit / enable channel from scan

In some areas the scan function may repeatedly lock on a chan-
nel at each cycle, for example if it is transmitting a carrier signal.
Rather than press Adv each cycle, selected channels may be
inhibited, or removed from the scan cycle -
1 2 : 5 5
DSC
I I n n h h
Adv
Instruction Manual
1 2 : 5 4
INT DSC
Hi T/W
M/S
Lite
S S c c a a n n
Rx
1 2 : 5 4
DSC
INT
Hi
Lite Inh
Adv
S S c c a a n n
2. In VHF mode
1 2 : 5 5
INT DSC
S S c c a a n n T/W
I I n n h h M/S
Rx S S c c a a n n
Select channel to be
Inhibited, then press and
hold Scan (double beep)
Press
and hold
19