Fisher & Paykel OR90SDBGFX User Manual page 30

First use
28
Remove the side racks to fit the Catalytic panels (if not already fitted)
Remove all shelves and trays.
1
For easier access to the fixing screws, you may remove the oven door first. See 'Removing and
2
refitting the oven door' in Care and Cleaning.
Remove the side racks on both sides:
3
Using a small coin or a flat-head screwdriver, loosen and remove both fixing screws.
4
Gently remove the side rack.
5
Fitting the Catalytic panels
Fit the catalytic panel. When fitting the catalytic panel make sure that
6
- the arrows are pointing upwards
-the panel with the hole in it is on the right oven wall.
Refitting the side racks
To refit the side racks
7
- make sure that they are the right way up, as in the illustrations, and that you
tighten the fixing screws.
If not already fitted, fit the telescopic sliding shelf supports. See "Care and cleaning' for
8
instructions.
Fig. 18 Refitting the side racks