Fisher & Paykel OR90SDBGFX User Manual page 26

Installation instructions
24
Connecting the power supply cable
Important!
This cooker must be connected to the electricity supply only by an authorised person.
Feeder cable section
This cooker must be connected to electrical supply using H05RR-F insulated cable
220-240V~ 3 x 1,5 mm
To connect the power supply cable to the cooker, it is necessary to:
Unhook the terminal board cover by inserting a screwdriver into the two hooks 'A' (fig. 14).
1
Unscrew the screw 'D' and open completely the cable clamp 'E' (figs. 15).
2
Connect the phase, neutral and earth wires to terminal board 'G' according to the diagrams in
3
Fig. 15.
Strain the feeder cable and block it with cable clamp 'E' (by screwing screw 'D').
4
Close the terminal block cover (check the two hooks 'A' are correctly hooked).
5
Important!
To connect the power supply cable DO NOT unscrew the screws fixing the cover plate behind the terminal
block. WARNING: If the power supply cable is damaged, it must be replaced only by an authorised service
agent in order to avoid a hazard.
Voltage and power consumption
220-240V ~ 50/60Hz 3680W 16A (230V)*
* Connection with wall box connection
2
cable.
A
Fig. 14 Terminal block
1
2
L1
3
4
N
L2
5
PE
D
E
220-240 V
1
L
1
2
3
N (L )
4
2
5
PE
Fig. 15 Connection diagrams
G