Fisher & Paykel OR90SDBGFX User Manual page 22

Installation instructions
20
Converting to a different gas type
This appliance is suitable for use with Natural gas or LPG (check the "gas type" sticker attached to
the appliance). To convert from one gas type to another, you need to replace the injectors, and
then adjust the minimum burning setting.
Replacing the injectors
1 Remove the trivets and burners from the cooktop.
2 Using a spanner, remove the injectors (shown in Figs. 9‐10‐11 following) and replace them with
ones according to the gas type (see the 'Table for the choice of injectors').
3 Fix the warning label (supplied with the conversion kit) at the back of the cooker, near the gas
inlet connection. This label states that the gas cooktop has been converted for use with LPG/
Natural gas.
Adjusting the minimum burner setting
4 See 'Adjusting the minimum burner setting' .
Note: The burners are designed so that regulation of the primary air is not required.
Rear wall
Suggested area for
gas mains connection
Fig. 8d Gas mains connection area.