Fisher & Paykel OR90SDBGFX User Manual page 16

Installation instructions Installation instructions
14
Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent it tipping accidentally, the anti-tilt bracket supplied must be fitted
according to the instructions below.
Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the floor-see
1
Fig.3) and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or electrical wires.
Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in
2
Fig. 3.
After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the left rear
3
foot slides under the bracket, as shown in Fig.3.
Replace the kickstrip using the two screws.
4
Important!
When sliding the cooker into place be careful not to trap the power supply cable in the anti-tip bracket. Pay
extra attention to the gas connection hose.
Beware of sharp edges when removing or replacing the drawer.
Dotted line showing the position
of the cooker when installed
Anti-tilt
bracket
Rear left
foot of cooker
Fig. 3 Attaching the
anti-tilt bracket and
sliding the cooker
into place