Superior DRL4543TEN Installation And Operation Instructions Manual page 26

UPGRADING DRL4543 TO INDOOR/OUTDOOR SEE-THRU
APPLICATION
WARNING: LDSTI must be installed before install-
ing LDSTO.
Installing Exterior Door
1. Center and level exterior door on rear face of the see-thru fireplace.
Exact dimensions for the location of the door are shown in Figure
41.
2. Using self tapping screws (provided) secure exterior door to the
face of the fireplace by drilling through holes on door into the
fireplace face (Figure 42). You may chose to drill pilot holes into
the face using a 1/8" drill bit. Do not use self tapping screws, use
any #10 x 1/2" screw.
3. In locations of extreme weather, it is recommended to apply a bead
of high temperature sealant around the edge where the exterior
door meets the fireplace face.
NOTE: When finishing the face of the exterior side of the fireplace,
use only non-combustible materials. You may extend up to the edge
of the exterior door covering up the screws used for installation.
Installing Outdoor Barrier F2253.
1. Using a flat head screwdriver, pop out the top and bottom trim
pieces an shown in figure 43.
2. Remove the outside screws on both top and bottom but leaving
two middle screws (top and bottom) in place.
3. Secure outdoor barrier using the four screws previously removed.
4. Secure top and bottom trims back in place.
Removing Exterior Glass Door
1. Using a flat head screw driver, pop out the top and bottom trim
pieces as shown in Figure 43.
2. Remove 8 screws at top and bottom of glass door and remove
glass door.
11 5/8" 11 5/8"
Figure 41 - Installing Exterior Door for See-Thru In/Out Application
26
FIREPLACE INSTALLATION Continued
Bottom Trim
11 5/8" 11 5/8"
1 19/32"
Superiorfireplaces.US.com
Figure 42 - Installing Exterior Door for See-Thru In/Out
Application
Top Trim
Figure 43 - Removing Exterior Glass Door for Cleaning
1 3/16"
3 1/2"
10 1/2"
10 1/2"
2 31/32"
Fireplace
Face
Exterior Door
Middle
Screws
Outside
Screws
126718-01C