Elna International Corps. SA
If the stretch stitch patterns are deformed when sewing the patterns with the feed balancing dial is
set at the standard position
Adjustment procedure:
1. Select the straight stretch stitch
2. Set the feed balancing dial at the standard position" ".
3. Place a piece of paper on the machine and lower the presser foot. Rotate the handwheel
several turns and check the needle marks in the paper.
4. Remove the cap E on the rear cover to access the adjusting screw G.
5. If the forward feed is longer (A>B): Turn the adjusting screw G in the direction of (C).
6. If the backward feed is longer (B>A): Turn the adjusting screw G in the direction of (D).
7. Attach the cap E.
3210 / 3230
Stretch Stitch Feed Balance
(see F), correct it as follows:
and set the stitch width control at "O".
Page 14
Service manual