Needle Bar Height - ELNA 3210 Service Manual

Elna International Corps. SA 3210 / 3230 Service manual

NEEDLE BAR HEIGHT

When the tip of the hook D meets the left side of the needle in ascending travel of the needle from its
left and lowest position, the distance between the top of the needle eye and the tip of the hook D
should be in the range of 1.6-2.0 mm.
Adjustment procedure:
1. Select the straight stitch and set the stitch width control at ''6.5".
2. Remove the needle plate A and bobbin holder B.
3. Turn the handwheel until the tip of the hook D meets with the right side of the needle.
4. Remove the face cover and loosen the setscrew C.
5. Adjust the needle bar height by moving the needle bar up or down.
6. Tighten the setscrew C.
Note:
Be sure that the groove on the needle bar F is facing right in the front.
7. Attach the face cover, bobbin case and needle plate.
Page 16