A2+/A4+/A6+/A8+
Cleaning and basic maintenance
8
Cleaning and basic maintenance
DANGER!
Risk of death via electric shock!
Disconnect the printer from the power supply before performing any maintenance work.
8.1
Maintenance plan
Maintenance task
General cleaning (see "8.3" on page 28)
Clean print roller (see "8.4" on page 28)
Clean printhead (see "8.5" on page 28)
+
For A2
, A4
Clean label sensor (see "8.6" on page 28)
Replace printhead (see "8.7" on page 29)
Replace print roller and rewind assist roller
(see "8.8" on page 31)
Tab. 8:Maintenance plan
8.2
Tools and cleaning agents
For adjustments and simple installation work, use the accompanying hexagonal wrench located in the
bottom section of the print unit. See Fig. 5, Item 8. No other tools are required for the work described
here.
Cleaning agents
•
soft brush
•
roller cleaner
Edition 5/06
+
label printers only:
Operating Instructions
•
soft cloth
•
cotton swabs
When
as necessary
each time the label roll is changed or
when the print image and label trans-
port are adversely affected.
direct thermal printing: each time the
label roll is changed
thermal transfer printing: each time
the transfer ribbon is changed
or when the print image is adversely
affected
when the label roll is changed
when errors in the print image occur
when print image and label transport
are adversely affected
•
pure alcohol
•
special cleaning pen
27