Error Messages And Recovery - CAB a2+ Operating Instructions Manual

Barcode/label printer
Hide thumbs Also See for a2+:
Table of Contents

Advertisement

A2+/A4+/A6+/A8+
Error treatment
9.3

Error messages and recovery

Error message
ADC malfunction
Barcode error
Barcode too big
Battery low
Buffer overflow
Card full
Device not conn.
File not found
FPGA malfunction
Head error
Head open
Head too hot
Invalid setup
Memory overflow
Name exists
No DHCP server
34
Cause
Hardware error
Invalid barcode contents, e.g.
alphanumeric characters in
numerical barcode
Barcode is too large for the
allotted area of the label
Battery of the PC card is dead Replace battery in PC card.
Data input buffer is full, and
the computer is attempting to
send more data
Memory card cannot accept
any more data
Programming does not
respond to existing device
Calling up of a file from the
memory card which does not
exist
Error in the selected download
font
Hardware error
Hardware error
Printhead not locked
Printhead excessively warm
Error in configuration memory Reconfigure printer.
Print job too large: e.g. due to
loaded fonts, large graphics
Field name in direct program-
ming entered twice
Printer is configured for
DHCP, and there is no DHCP
server or the DHCP server is
currently unavailable
Operating Instructions
Error recovery
Switch printer off and on again.
If it occurs again → Service.
Correct barcode contents.
Shrink or shift barcode.
Use data transfer with protocol (prefera-
bly RTS/CTS).
Change memory card.
Connect an optional device or correct
programming.
Check contents of the memory card.
Cancel print job,
change font.
Switch printer off and on again.
If it occurs again → Service.
Switch printer off and on again.
If it occurs again → replace printhead
(see "8.7" on page 29).
Lock printhead.
The print job continues automatically
after pausing.
If this occurs repeatedly, reduce the
heat level or print speed in the software.
If it occurs again → Service.
Cancel print job. Reduce amount of data
to be printed.
Correct programming.
Deactivate DHCP in the configuration
and issue a permanent IP address.
Notify the network administrator.
Edition 5/06

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

A4+A6+A8+

Table of Contents