Standing Operation Pedal; 14-1.Installing The Foot Plug - Brother S-710A Service Manual

14. STANDING OPERATION PEDAL

Some sub-classes are not equipped with
a foot plug set.
In such cases, install the foot plug set
(J02953-001) by the following procedure.
14-1. Installing the foot plug
Wait at least 10 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
(2)
(1)
(3)
(6)
(2)
(5)
<CN3>
<With foot plug set>
Foot plug
DANGER
1. Remove the three screws (1), and then remove the
1863M
2. Install the foot plug (3).
3. Install the ground wire with the screw (4).
(3)
1864M
4. Insert the connector (5) of the foot plug (3) into the
5. With the connector (5) passed through the opening (6),
1865M
SL-710A
14. STANDING OPERATION PEDAL
1861M
treadle unit (2).
CN3 connector of the control circuit board.
install the treadle unit (2) with the three screws (1).
<Without foot plug set>
1862M
96