12-5.Memory Switches - Brother S-710A Service Manual

12. FUNCTION SETTING METHODS
12-5. Memory switches
Memory switches 01 - 08
01 Parameter setting
02 Interlocking along with forward step
03 Power supply drop check
04 Limited sewing speed
05 Needle penetration force
06 Overtime function
Independent backtacking
07
setting
Slow start function (From design
08
change C onward)
(NOTE 1) When the power is turned on again, sewing speed can be set up to 5,000 rpm.
Memory switches 11 - 18
Thread trimming and thread wiper
11
output
Presser foot position after thread
12
trimming (See NOTE 2.)
Presser foot position after the machine
13
stops with the pedal in neutral
14 Actuator switch
15 Slowdown stop control
16 Lower thread remaining detection
17 Half-stitch correction
18 Reverse stitch correction
(NOTE 2) It is activated when DIP switch 1 is set to on.
(NOTE 3) A forward stitch can be corrected when the LED of the correction switch is lit. A half stitch or reverse stitch can
be corrected when the LED of the correction switch is not lit.
87
ON Parameter setting can be changed.
OFF Parameter setting change is prohibited.
Forward step is possible during backward step
ON
(for thread trimming).
Forward step is impossible during backward step
OFF
(for thread trimming).
Power supply drop check (reset detection) function is
ON
activated.
OFF Without the above-mentioned function
The same as settings of DIP switches 6 and 7.
ON
(See NOTE 1.)
OFF Maximum sewing speed is limited to 4,700rpm.
ON Needle penetration force is strong.
OFF Needle penetration force is ordinary.
ON Overtime function disabled
OFF Overtime function enabled (3 minutes)
ON Backtacking speed is not limited by high speed setting
speed
OFF Backtacking speed is limited by high speed setting
Number of stitches and sewing speed can be set using the
ON
operation panel
OFF Low speed is fixed at 2 stitches
ON Without thread trimming and thread wiper
OFF With thread trimming and thread wiper
ON Presser foot is raised when the foot pedal is in neutral.
OFF Presser foot is lowered when the foot pedal is in neutral.
ON Presser foot is at its highest position.
OFF Presser foot is at its lowest position.
ON It is used as the thread trimming switch.
OFF It is used as the reverse and correction switches.
ON Ordinary slowdown stop and control
OFF Slowdown and stop control with 1 stitch elimination
ON Unable to be used
OFF Able to be used.
ON A forward stitch or half stitch can be corrected. (See NOTE 3.)
A forward stitch can be corrected. A half stitch cannot be
OFF
corrected. (See NOTE 3.)
A forward stitch or reverse stitch can be corrected.
ON
(See NOTE 3.)
A forward stitch can be corrected. A reverse stitch cannot be
OFF
corrected. (See NOTE 3.)
SL-710A