Presser Foot Mechanism - Brother S-710A Service Manual

6. ASSEMBLY

6-8. Presser foot mechanism

(1)
(2)
(3)
(4)
(6)
(5)
(7)
(20)
(19)
(18)
(17)
(14)
(15)
(16)
(11)
39
1. Insert the shaft (1) into the arm.
2. Place the tension release plate (2) and the washer (3)
3. Place the presser bar lifter lever (4) onto the shaft (1).
1741M
4. Push the shaft (1) to the right, and then install retaining
5. Move the shaft (1) to the left, and then tighten the set
(2)
6. Place the spring (7) onto the shaft (1), and then attach
(1)
(7)
(8)
7. Place the washer (8) onto the shaft (1), and then install
(9)
1742M
8. Insert the presser bar (10) through the top of the arm,
9. Attach the wick (12) to the presser bar (10).
10. Install the guide bracket (13) to the arm and to the
11. Install the thread guide (14) to the guide bracket (13),
12. Place the washer (17) on top of the presser bar (10),
(10)
13. Install the adjusting screw (20) to the top of the arm.
(13)
(12)
1743M
SL-710A
onto the shaft (1).
ring E (5) to the left-side groove.
screw (6) on the arm.
it to the tension release plate (2) and to the pin of the
arm.
retaining ring E (5) to the right-side groove.
and insert it into the bush (11).
presser bar (10).
and provisionally tighten it with the bolt (15) and the
screw (16).
and then insert the spring (18) and the spring guide
(19) through the top of the arm.