Standing Operation Pedal; Installing The Foot Plug - Brother S-7200A Service Manual

11. STANDING OPERATION PEDAL

11. STANDING OPERATION PEDAL
The foot plug assembly CDD (J04099-001) that is sold separately is required.

11-1. Installing the foot plug

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
1.
Connect the foot plug (1) to connector CN3 on the control circuit board.
2.
Connect the standing pedal connector (2) to the foot plug (1).
3.
Secure the standing pedal cord (3) with a repeat cable tie (4).
51
DANGER
S-7200A
2339M