Table of Contents
Advertisement
4 Parametres programming
4.1 Programming by phone
4.1.1 Programming enter
You can enter programming mode by following ways:
1. password – incoming call only! – pick up the phone and dial phone
number where is door intercom connected
door intercom is connected to PBX or PSTN line number of building where is
door intercom installed and let operator connect you to appropriate door
intercom extension)
tone – via. capture 3.1 page.21) and you have to dial within 10 sec
#xxxx, when xxxx is service passsword to enter programming mode
(default xxxx=0000)
programming mode enter and after a while you hear programming tone
(via. capture 3.1 page.21).
2. switch "SERVIS" – incoming call only! – the connection you establish
the same way like in item 1. but only when DIP1 switch is in position
"on". Then door intercom after picks up going directly into programming
mode without neccessity to insert service password. (via. capture 3.1
page.21).
4.1.2 Parametres programming
Stand by stage of programming is announced by programming tone into
which door intercom always returns after time out (5sec) whenever you started
to programm.
There are two kind of parametres you can programm. First are parametres
with fix length – Most of parametres are those. The parametr is saved
immediatelly after inserting mandatory length – you hear confirmation tone.
Second are parametres with variable length (parametr 1, 2,32,33,34). Saving
and confirmation of those parametres is made after 5 seconds inserting last dial.
There is one case when those parametres are saved immediately and it is filling
up maximal number of characters (numbers) – at parametr 1 and 2 it is 24,
parametr 32,33,34 it is 6.
When
during
unacceptable then door intercom sends error tone. The parametr is not saved
even changed. Door intercom returns to stand by and you can start again
parametr programming of programm other parametr.
When you enter programming mode and do not make any dialling for
30seconds the door intercom will hang up. After each dialled DTMF tone the
time is prolonged about 30seconds. You can finish programming mode also by
dialling parametr 9.
26
. Door intercom picks up (you hear pick up acoustic
. When all is correct you hear acoustic tone of
programming
(either extension number when
insert
number(character)
BRAVE – user guide
which
is
Advertisement
Table of Contents
