Chapter 3
[1]
3.5.6.8 Removing the Right Frame
1) Remove the right frame [1].
- 3 screws [2]
3.5.6.9 Removing the Plate
1) Remove the plate [1].
- 1 connector [2] on the ECNT board
- 3 screws [3]
3.5.6.10 Removing the Left Frame
1) Remove the left frame [1].
- Remove the cable [2] from the guide.
- 3 screws [3]
3-38
[3]
[2]
[1]
F-3-241
[2]
[1]
[2]
F-3-242
[1]
[2]
[3]
F-3-243
3.5.6.11 Removing the Power Supply Shield Plate
1) Remove the cable from the cable guide.
- 1 connector [1]
[1]
0012-1722
2) Remove the power supply shield plate [1].
- 9 screws [2]
0012-1723
[1]
3.5.6.12 Removing the Power Supply Assembly
1) Remove the 3 screws [1]. (The external cover is omitted from the
illustration below to show the instructions clearly.)
2) Remove the four connectors [2] as well as the flat cable [3] on the ECNT
board.
After having removed the flat cable [3], store it inside the unit to protect it
from damage.
0012-1724
[3]
[1]
[2]
F-3-244
F-3-245
[1]
F-3-246
[3]
0012-1725
[1]
0012-1726