Installation and Setup
Camera Installation
Preparing the Camera
Preparing the Mounting Surface
20
1.
Rotate the dome bubble counterclockwise
until it disconnects.
2.
Pull the turret to remove it.
3.
Rotate the camera counterclockwise until it
disconnects from the skirt.
4.
Set aside the dome bubble, turret, and
camera.
1.
Use the mounting template provided to mark the mounting surface for the screw
holes and the wire access hole (see
Figure 2-2
Surface Mounting Template
2.
Pre-drill the holes as marked with the mounting template, using the recommended
hole size for the screws being used.
Camera
Turret
Surface Mounting Template
Drill these holes for the
mounting screws.
Cut this hole, then pull the
power wires through it.
Skirt
Dome bubble
on page 69).