Set focus
(top)
Local
video
output
Set focal length
(bottom)
Document 800-09312V2 Rev A
08/2012
Performance Series Indoor Day/Night H.264 IP Camera User Guide
Note
Please wait approximately 60 seconds after connecting to a power source for
video to appear on the local video output.
2.
Connect the supplied BNC video cable to the local video out connector to view the
video signal on a standard monitor (see
monitor).
3.
Loosen the thumbscrew that locks the gimbal assembly in place (see
adjust the tilt rotation.
4.
Adjust the gimbal assembly to the desired view. Orient as shown in
maintain the correct picture orientation.
5.
Re-tighten the thumbscrew to lock the gimbal assembly in place.
6.
Disconnect the BNC video cable.
Note
Figure 2-5
illustrates the ways in which you can adjust your camera.
Caution
Adjust the camera field of view only by moving the gimbal. Do not
move the camera lens to adjust the camera field of view as this might
result in irreparable damage.
Figure 2-5
Gimbal Adjustment
Top view
Loosen thumbscrew to
adjust tilt rotation (A)
Figure 2-5
below to connect a local video
Angle view
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
Figure
2-5) to
Figure 2-5
to
25