Preparing For Camera Installation; Step1. Removing The Dome Bubble And Turret; Step 2. Removing The Gimbal; Figure 2-2 Mounting Holes And Removed Gimbal - Honeywell HD4MDIH User Manual

Installation and Setup

Preparing for Camera Installation

Step1. Removing the Dome Bubble and Turret

Step 2. Removing the Gimbal

20
1. Using the supplied Allen key, loosen the captive screws on the dome bubble (see
Figure 2-1 on page 19). Remove the dome bubble and set it aside.
2. Gently pull the turret off the gimbal assembly, then set it aside.
To gain better access to the mounting holes and the wiring board, remove the gimbal from
the enclosure base.
1. Squeeze the 4 black tabs until they are free of the black clips.
2. Elevate the hinge until the gimbal is above the housing and you have access to the
camera board connections and mounting holes.
Figure 2-2 Mounting Holes and Removed Gimbal
Metal
hinge
Mounting
holes
Black tabs (x4)
Black clips (x4)
Caution
When elevating the
hinge, do not
overstress the two
ribbon cables. If
necessary, rotate the
gimbal to provide
additional slack.