Connecting The Wiring - Honeywell NTSC User Manual

Connecting the Wiring

Document 800-09312V2 Rev A
08/2012
Performance Series Indoor Day/Night H.264 IP Camera User Guide
Note Other fasteners (preferably stainless steel) can be used, provided they are not
larger than the screw holes on the mounting template.
Caution Installation must be performed by a qualified electrician. The power
wire gauge for the distance and the number of cameras must be
determined to maintain 24 V AC at each camera.
Connecting Power
Caution The use of a CSA Certified/UL Listed Class 2 power supply is required
to ensure compliance with electrical safety standards.
Note Check the power source from the external power supply before applying
power to the camera.
1. Connect the appropriate power supply for your installation:
• 24 V AC power supply (proceed to
- or -
• Power over Ethernet (IEEE 802.3af) 48 V DC power supply
Note Connect power either from a 24 V AC source or CAT5 Ethernet connector
(PoE). It is NOT recommended to connect both power sources at the same
time.
Note If you are using PoE (802.3af), power will automatically be supplied to the
camera through the network cable.
step 2)
21