Direct Operation - FireplaceXtrordinair 98501001 Installation And Owner's Manual

DIRECT OPERATION

Plug the heater into a suitable outlet.
1) "Power ON/OFF"
Set this switch to position I to turn the product ON. Setting it to O to turn the product OFF. The
POWER LED will be lit when the fireplace insert is on.
2) "Heat control button"
Press the HEAT button repeatedly to set the heater to the desired heat set. The HEATER LED will
indicate the current setting for the heater as shown below:
HEATER LED = Red = 1500W HEAT OUTPUT
HEATER LED = Blue = 750W HEAT OUTPUT
HEATER LED = Purple = AUTO MODE
HIGH / 1500W
HEATER INDICATOR
Auto Mode
In this mode the heater will automatically turn on and off. When the room temperature drops below
71° F (22° C) the heater will turn on to the high heat setting (1500 watt). When the room temperature
is between 71° and 77° F (22-25° C) the heater output will switch to the low heat setting (750W). When
the room temperature goes above 77° F (25° C) the heater will turn off.
3) "Flame control button"
Press "Flame" button to adjust the flame intensity and ember bed brightness.
Press the "FLAME" control button to cycle through LO, MED, HI and OFF.
LOW / 750W
HEATER INDICATOR
OFF
15
1. Power ON/OFF switch
2. Heat control button
3. Flame control button
4. HEATER LED
5. POWER LED
AUTO MODE
HEATER INDICATOR