FireplaceXtrordinair 98501001 Installation And Owner's Manual page 13

REMOTE CONTROL OPERATION (continued)
Note
. The remote control requires 2 AA batteries (not included).
Note:
The heater may release a slight odor the first time it is turned on. This is normal. The heating
elements inside the heater will burn off any accumulated oils or dust during initial heating. This may also
occur when dust accumulates on the heating elements over periods of non-use.
2. When operating the remote make sure to point the remote at the center of the fireplace insert. Each time you press
a button on the remote the LED indicator on the top right of the remote should blink and the fireplace insert will "BEEP".
If the LED fails to blink check the batteries. It takes up to one second for the fireplace insert to respond to the
transmitter. DO NOT PRESS THE BUTTONS MORE THAN ONCE within two seconds. This allows the fireplace
insert to respond to the remote.
3. Power on button: The power – on button at top left corner of the remote is the main ON/ OFF power button.
This will turn off all the functions (heater and display). If you turn the fireplace insert OFF, then ON, the fireplace
insert will return to its last heater and display settings.
4. Flame Power On button " DISPLAY ON OFF ": This button controls both the ember and flame effect. Once the
flame effect is ON use the + and – buttons as explained below to adjust the flame brightness as desired. Press this
button again to turn OFF the flame effect.
a. The – or + buttons control the brightness of EMBER.
To increase the brightness of ember bed, press and release the + button. Each time you press this button
the brightness will increase small amount, until the maximum is reached.
To decrease the brightness of ember bed, press and release the – button. Each time you press this button
the brightness will decrease a small amount, until the minimum brightness is reached.
b. The FLAME INTENSITY– or + buttons control the brightness of FLAME.
To increase the brightness / flame Intensity , press and release the + button. Each time you press this
button the brightness will increase by a small amount, until the maximum is reached.
To decrease the brightness / flame Intensit y , press and release the – button . Each time you press this
button the brightness will decrease by small amount, unitl the minimum brightness is reached. You can mix the
ember and the flame to create a realistic flame effect.
13