Table of Contents
Advertisement
Before You Begin
•
Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.
Location of Controls
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob
Shut-Off Valve
© Travis Industries
Operation
ON/OFF Switch
Blower Control
Gas
Control
Shut-Off Valve
Valve
This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark
directly next to the pilot, igniting the pilot flame.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
Turn the knob clockwise to shut gas off, counter-clockwise to turn gas on.
NOTE: this valve is used for installation and service, not for daily use.
4040927
The Pilot Flame can be
found below the back log.
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
Pilot Igniter
Swing the control cover down to access the gas
control valve and pilot igniter.
Gas Control Knob
Flame Adjust Knob
100-01158
39
Advertisement
Table of Contents
