Table of Contents
Advertisement
5. Maintenance
General Maintenance
After every 50 operating hours, at least
once a year and after cleaning:
grease or Bio-lubricating oil (e.g. speed
hand lever, handle bearing etc.).
Cleaning
Cutter bar
5
After each mowing, clean cutter bar
5
bricating grease to all gliding parts.
52
Every time You
take up operation
watch out for fuel
and oil leakage,
repair if neces-
sary.
Regularly check
bolts and nuts for
tight fit, re-tighten,
if necessary.
Lubricate all
gliding and mov-
ing par ts with
Bio-lubr icating
thoroughly with
water. Remove
the knife and re-
move dir t col-
lected between
knife blades. Af-
ter cleaning, ap-
ply Bio-lubricat-
ing oil or Bio-lu-
Fit knife guard!
agria Power Mower 5400
Mowing Drive and Machine
I
chine and operate mowing drive for a
short time to press out penetrated wa-
ter. Apply grease generously to leave a
grease neck around bearing to prevent
water, plant sap and dirt from penetrat-
ing.
Engine
After cleaning with
air-compressed
water jets immedi-
ately lubricate the
pivot arm bearing
on the moving
drive lubrication
points on the ma-
Clean engine only
with a cloth. Avoid
spraying with water
jets, as water might
penetrate into igni-
tion and fuel sys-
tem and cause
malfunctions.
Advertisement
Table of Contents
